Southern California heating, air conditioning and indoor air quality from a local AC contractor you can trust!
20 Point Heating Inspection
1.
CHECK THERMOSTAT CALIBRATION A properly calibrated thermostat reduces your energy bills and increases comfort.
2.
CLEAN OR REPLACE AIR FILTER Dirty air filters can increase energy bills up to 40% an cause expensive equipment breakdowns.
3.
CHECK AND ADJUST AIR FLOW Having the correct temperature rise is critical to comfort and efficiency.
4.
CHECK AND ADJUST BLOWER COMPONENTS A clean, properly adjusted blower and components are key to equipment reliability.
5.
LUBRICATE ALL MOVING PARTS Poor lubrication causes drag in motors and drive shaft, thereby increasing energy consumption and causing premature motor failure.
6.
CHECK AND ADJUST BURNERS Properly adjusted burners assure peak efficiency and guarantee smooth ignition.
7.
SAFETY INSPECTION Check all system safeties to assure safe equipment operation.
8.
CHECK AND ADJUST IGNITION SYSTEM A properly adjusted ignition system assures safe, reliable ignition.
9.
CHECK AND TIGHTEN ALL ELECTRICAL CONNECTIONS Loose or burned wires can cause costly system breakdowns.
10.
CHECK FLUE DRAFT Proper venting of flue gases is critical to the safety and efficiency of your furnace.
11.
CHECK AND ADJUST GAS PRESSURE Proper gas pressure measure is critical to complete combustion and energy efficiency.
12.
CHECK VOLT AND AMP DRAW ON ALL MOTORS This check can find problems inside the windings of the motors giving us a chance to replace the motor before it becomes an emergency call.
13.
CLEAN HEAT EXCHANGER A clean, unobstructed heat exchanger improves energy efficiency.
14.
VISUALLY INSPECT HEAT EXCHANGER Visually inspect the heat exchanger to be sure there are not cracks and/or holes.
15.
INSPECT FLUE PIPE A sealed flue pipe with the proper rise per foot is critical to safe venting of combustible gases.
16.
ADJUST THERMOSTAT ANTICIPATOR A properly adjusted thermostat anticipator improves comfort.
17.
DUST FURNACE CABINET A clean furnace looks good.
18.
CHECK AND ADJUST FAN CONTROL A properly adjusted fan control improves comfort.
19.
CHECK FOR GAS LEAKS Sealed gas lines are safe gas lines.
20.
TEST CYCLE FURNACE FOR PROPER OPERATION When we are complete with your tune-up, we will test cycle your system to assure proper operation.
